Chapter 03

Vial basics

The words you'll hear from the moment a vial arrives to the moment it goes in the fridge. Tap any word to see what it means.

  1. 1

    It arrives as powder

    Peptides usually ship freeze-dried as a white cake or 'puck' at the bottom of a sealed glass vial. The label shows its strength in mg.

  2. 2

    Check what's inside

    Match the vial's lot number to its lab report to confirm identity and purity before anything else.

  3. 3

    Choose the liquid

    The powder is dissolved in a sterile liquid. Bacteriostatic water is used for vials meant to last several days.

  4. 4

    Mix it

    Adding liquid to powder is called reconstitution. The amount of liquid you add sets the concentration. Swirl gently, never shake.

  5. 5

    Measure

    Small volumes are measured with an insulin syringe marked in units. On a U-100 syringe, 100 units equals 1 mL.

  6. 6

    Store it right

    Once mixed, most peptides go in the fridge away from light. Heat, light and shaking cause them to break down.

Storage at a glance

Powder, unopened

Cool, dry, dark. Often fridge or freezer for long-term.

Mixed with BAC water

Fridge, 2–8°C (36–46°F), away from light.

Mixed with sterile water

Intended for single use.

SubQ vs IM vs oral vs nasal

The same peptide can act very differently depending on how it enters the body. The key idea is : how much actually reaches your blood.

SubQ

A small needle into the fat under the skin.

Reaches blood

High

Upside: Most reliable and precise. Easy to measure in units. The usual route for peptides.

Downside: Needles, mixing and careful clean technique.

Intramuscular

A longer needle deep into a muscle, like the shoulder or thigh.

Reaches blood

High

Upside: Absorbs a bit faster than SubQ and handles larger volumes.

Downside: Longer needle, more discomfort, and it takes more skill to do safely.

Oral

Swallowed as a pill, capsule or liquid.

Reaches blood

Very low

Upside: No needles, nothing to mix.

Downside: Stomach enzymes break most peptides down, so much higher doses are needed.

Nasal

Sprayed into the nose and absorbed through its lining.

Reaches blood

Low to medium

Upside: No needles and skips the stomach.

Downside: Only works for some peptides. Dose per spray is less exact.

Common beginner mistakes

Most problems come from a handful of easy slips. Here's what to watch for.

Mixing up mg and mcg

1 mg is 1,000 mcg. Reading one as the other means a dose 1,000 times off. Always check which unit you're working in.

Treating syringe units like IU

Syringe units are volume marks. IU measures biological activity. They are not the same thing.

Shaking the vial

Shaking can damage the peptide. Let the water run down the side of the vial and swirl gently.

Spraying water onto the powder

Aim at the glass wall, not straight at the powder, so it dissolves slowly.

Forgetting how much water you added

Your units-per-dose depends on it. Write it on the vial or save it in My Stack.

Reusing needles

Needles go dull and pick up bacteria after one use. Use a fresh one every time.

Skipping the alcohol swab

Wipe the stopper before every draw to keep the vial clean.

Leaving a mixed vial out

Mixed vials belong in the fridge, away from heat and light.

Injecting the same spot every time

Rotate between sites to avoid lumps and irritation.

Using a cloudy or discolored vial

A clear solution turning cloudy can mean it has broken down or been contaminated.

General vocabulary context only. Always follow the storage and handling directions from your pharmacist or provider.